1. Cut out the simple-snowman templates. Thinly cut off the top and bottom of your soap to remove the brand logo and create a flat surface. Trace the snowman's shape onto the soap with a toothpick.
2. Using a paring knife, cut out the snowman's shape a bit bigger than the outline you traced in previous step.
3. Cut off the excess soap with a carving knife and round the edges of the snowman.
4. Cut off a piece of soap to carve a beanie. Place the beanie template on the small piece of soap and trace the shape onto the soap.
5. Roughly cut out the shape of the beanie, then trim and shape it into a beanie.
6. Carve a folded cuff in the beanie.
7. Using a paper clip, scrape out the inside of the beanie to fit the head of the snowman.
8. Cut the soap into a 1.2 cm (1/2 in) thick piece. Then trace around the glove templates.
9. Roughly cut out the shape of a glove, then trim and shape it into a glove. Repeat it to make a second glove.
10. Make a hole in each glove.
11. Place the template on a small piece of soap, then trace the shape of the nose. Then trim and shape it into a dome.
12. Place the nose on the snowman's face, trace around the edge of the nose.
13. Holding your knife vertically, cut the nose shape and cut off the inside it. Then scrape out the inside with a paper clip
14. Attach the nose to the face. Tip: Fill the gap with soap scraps if it exists.
15. Carve a button in the body.
16. Draw two circles for eyes with a toothpick.
17. Mark where you'll attach the arms with a toothpick. Then make a hole in both sides.
18. Cut the toothpick into short pieces.
19. Stick the toothpicks in the holes and put the gloves.
20. Paint the eyes with nail polish and remove the excess polish with a carving knife.
21. Put the beanie on your snowman. Done!
